Klüber Klüberpaste UH1 84-201

Klüber Klüberpaste UH1 84-201 is a white lubricating and assembly paste for the food-processing and pharmaceutical industries

Benefits for your application

– Reliable adhesion to the friction point, also when subject to humidity
– Good compatibility with high-alloy steels
– ISO 21469 certified – supports the compliance with the hygienic requirements in your production.

Description

Klüberpaste UH1 84-201 is a white lubricating and assembly paste for versatile lubricating and assembly purposes in hygienically sensitive environments. It contains fully synthetic base oils and a special blend of organic and inorganic thickeners. Klüberpaste UH1 84 201 is water-resistant and provides good corrosion protection. It is therefore suitable for friction points affected by humidity which normally require the use of special products.

Klüberpaste UH1 84-201 is NSF H1 registered and therefore complies with FDA 21 CFR § 178.3570. The lubricant was developed for incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical or animal feed industries. The use of Klüberpaste UH1 84-201 can contribute to increase reliability of your production processes. We nevertheless recommend conducting an additional risk analysis, e.g. HACCP.

Application

Klüberpaste UH1 84-201 is generally suitable for almost all friction points in the food-processing and pharmaceutical industries

– as an assembly paste for transition and loose fits to prevent fretting corrosion,
– as a long-term lubricant for low-speed guide rails, hinges, rollers, chains, etc

Application notes

Before applying the paste, it is important to clean and degrease the contact surfaces thoroughly. A thin layer of the paste is then applied by brush, leather cloth or synthetic sponge.

Klüberpaste UH1 84-201 spreads easily over the entire surface, preventing excessive lubrication at lubrication points without reservoir.
When using the paste on small gears, make sure the tooth faces are evenly greased. Before applying the product to plastic components it should be tested for compatibility with the original material.
Opened packs must be thoroughly closed again after use to protect the paste from contamination.
The friction values indicated on page 2 in the Section Product Data were determined with two different materials. Other materials/surfaces have to be checked accordingly.

Looking for any other product in Kluber Lubrication or other Lubricant ? Just give us a call.