Klüber Klüberalfa MR 3

Klüber Klüberalfa MR 3 Is a universal sliding fluid.
Klüber Klüberalfa MR 3 is an Universal sliding fluid for seals, guideways and plastic friction points.

Your benefits at a glance

– Reduced noise and optimised friction
– Can be combined with numerous material combinations
– Easy and reliable application

Your requirements – our solution

Car manufacturers are confronted with the need to prevent creaking noises (NVH requirements), in particular when a new vehicle model is being launched. The sliding fluids Klüberalfa MR 3 based on PFPE are resistant to evaporation and were specifically developed for NVH requirements and lifetime lubrication. They offer a less expensive alternative to other noise-reducing products such as
films or adhesive tapes.

Klüberalfa MR 3 products are highly compatible with most elastomers and plastics. Due to their being visually neutral, they can be used for applications in car interiors as well as in other industrial sectors.

Klüberalfa MR 3 is available in three different viscosities and supplied in a pump spray dispenser that does not release greenhouse gases.
It is easy to use in economically small quantities and does not give off combustible or flammable solvent vapours. The product
forms a homogeneous lubricating film.

Application

Due to its good compatibility, Klüberalfa MR 3 may be used in combination with most materials, e.g. leather, textile or plastic, in car interiors or on the car body.

Klüberalfa MR 3 is compatible with most thermoplastics or thermosetting plastics used, for example, in dashboards, seat and sunroof sliding rails, arm rests, seat adjustment mechanisms, door and sunroof seals.

Perfluorinated polyether oils are generally regarded as neutral towards elastomers and plastics (possible exception: highly fluorinated rubber). Nevertheless we recommend testing compatibility with the material to be used, especially prior to series application.

Application notes

For optimum lubrication results, we recommend cleaning the friction points with white spirit 180/210 followed by Klüberalfa XZ 3-1 before using Klüberalfa MR 3 for the first time. Then blow the surfaces with clean, dry compressed air or hot air to remove white spirit residues. For initial lubrication, the friction points must be clean and bright, i.e. free from oil, grease, perspiration and contamination

Looking for any other schmierstoffe product in Kluber Lubrication or other Lubricant ? Just give us a call.