– Long component life
– over a wide service temperature range
– when exposed to aggressive chemical agents
– due to a long calculated grease life
– Improved component performance
– due to low starting torques even at low temperatures
– due to resistance to high speeds
– due to friction values being largely independent of temperature
BARRIERTA is Europe’s oldest high-quality brand of high temperature lubricants based on perfluorinated polyether oil (PFPE). Today the name of BARRIERTA is widely regarded as synonymous with long-term stability and thermal resistance.
BARRIERTA greases are the first choice of lubrication experts in many sectors worldwide. BARRIERTA K greases enable long-term use under high temperatures and influence of media, while at the same time requiring low running torques at low temperatures. This was made possible by Klüber’s careful selection of raw materials and the specifically developed thickener.
BARRIERTA K greases are highly suitable for the long-term lubrication of rolling and plain bearings, where only low driving power is available and where long-term stability is required under changing environmental loads. Even at extremely low temperatures, BARRIERTA K greases are soft enough so as not to overload low-power drive units, while on the other hand they withstand temperatures as high as 200°C and beyond.
BARRIERTA K greases are used for a wide range of applications as for-life lubricants in automotive, electrical and precision engineering.
The BARRIERTA K greases good temperature resistance and their compatibility with plastics and elastomers – which is typical of PFPE lubricants – make them highly suitable for the lubrication of engine valves and seals as are found in hydraulic cylinders. BARRIERTA K greases enable long runtimes with low noise generation and low friction coefficients. The resistance of BARRIERTA KM 192 against brake fluids, type DOT 3, 4, 5 and 5.1, has been confirmed in an individual test.
BARRIERTA K grease stand out for their neutral behaviour towards elastomers and plastics. Owing to the many different varieties of elastomers and plastics and varying operating conditions, we recommend checking their compatibility with the component material prior to series application.
For optimum lubrication results, we recommend cleaning the friction points with white spirit 180/210 and then Klüberalfa XZ 3-1. Upon cleaning apply clean dry compressed air or hot air to remove any remaining white spirit residues. For initial lubrication, the friction point must be clean and bright (i.e. free from oil, grease or perspiration) and free from particles. The various technical sales departments at Klüber Lubrication may be contacted at any time to ensure optimum results with this special lubricating grease.
© 2018 DM-SCHMIERSTOFFSERVICE GMBH. ALL RIGHTS RESERVED.